Insulation

Magnet wire thermal classes explained: from Class 105 to Class 240

What thermal class means, how it is tested, and which enamel to use at each temperature.

Magnet wire thermal classes explained: from Class 105 to Class 240

Key takeaways

  • Thermal class is the temperature at which the insulation is expected to last about 20,000 hours in a thermal endurance test.
  • The usual classes are 105 (A), 130 (B), 155 (F), 180 (H), 200 (N), 220 (R) and 240.
  • Pick a wire one class above your hot-spot design temperature to gain lifetime margin.
  • Higher classes use imide chemistry: polyesterimide, polyamide-imide and polyimide.

What thermal class means

The thermal class of a magnet wire is the temperature in °C at which its insulation reaches end of life after about 20,000 hours in an accelerated ageing test, as defined in IEC 60172 and ASTM D2307. It is a rating of the insulation, not the conductor.

Running a winding 10 °C above its rating roughly halves insulation life. Running 10 °C below roughly doubles it. That rule of thumb is why designers keep margin between hot-spot temperature and wire class.

Classes and the enamels behind them

Class (°C)LetterTypical enamelCode
105APolyvinyl formal, oleo-resinPVF
120EPolyvinyl acetal, polyurethanePVA, UEW
130BPolyurethane, polyesterUEW, PEW
155FModified polyester, polyurethane 155PEW, UEW
180HPolyesterimideEIW
200NPolyesterimide + polyamide-imide overcoatEI/AIW
220RPolyamide-imide, EI/AIW 220AIW
240–PolyimidePIW

Choosing a class

  1. Find the hot-spot temperature of the winding at full load and highest ambient, not the average winding temperature.
  2. Add margin. Most designers pick one class above the hot-spot to cover overloads and ageing.
  3. Check the system. Varnish, slot liners and leads must be rated for the same class. A Class 200 wire in a Class 155 system is a Class 155 system.
  4. Check the process. Solderable polyurethane is limited to about 155–180 °C. For higher classes you must strip the enamel mechanically or chemically.

Beyond temperature

Higher-class enamels bring other benefits. Polyamide-imide overcoats add abrasion resistance for automatic winding, resistance to refrigerants for hermetic compressors, and better resistance to partial discharge in inverter-fed motors. If your motor runs on a variable frequency drive, ask about inverter-grade enamel even at moderate temperatures.

What we supply

Our round copper and round aluminum wires are available from Class 130 to Class 220, and polyimide builds to Class 240. Use the product filter to see every product by thermal class.

Frequently asked questions

What thermal class is Class H magnet wire?

Class H is 180 °C, usually achieved with polyesterimide (EIW) enamel.

Can I use Class 200 wire in a Class 155 motor?

Yes, and it adds lifetime margin, but the insulation system rating stays at the lowest-rated component, so the motor remains Class 155 unless every material is upgraded.

Need help choosing?

Send your application and operating temperature. We will recommend the wire and quote it.